« Why You Should Attend Solidworks World 2008 Reason 7: Solidworks All-Stars... | Main | Why You Should Attend Solidworks World 2008 Reason 5: Sneak Peak At Solidworks 2009 »

December 18, 2007

Never Fear, It Won't Disappear...

The once annoying problem of the flyout feature tree disappearing during mates, seems to have been solved once again in SW2008.

Tree As you can see, once the tree is in flyout mode, and you select the first tree item, the flyout stays put for a second selection.  I remember this being fixed at some point in an earlier version, only to reappear after a service pack.  Lets hope its fixed for good this time!

TrackBack

TrackBack URL for this entry:
http://www.typepad.com/t/trackback/861717/24317828

Listed below are links to weblogs that reference Never Fear, It Won't Disappear...:

Comments

It's still broken here Mike on 2008 SP1.0. I wish they would fix this however, it's so annoying. It was working correctly in the early beta releases.

Post a comment